- IL-560-2110 - Suction cup mount. The 3" dia. cup will screw into the end or side of the light. Fine where a smooth surface exists where the light needs to mount. A safety line should be tied to the light.
- IL-560-2113 - "C" Clamp mount. The clamp screws into either the end or side of the light. Attach this light to a gunwale, or any lip less than 2-1/2 inches thick. This light also comes with an 18" pole and a wider variety of mounting hardware (see below)
- IL-560-2112 - Flange Mount. This light comes with a hard rubbery 2-1/4" dia. flange that is designed to be glued to an inflatable dinghy, but could actually be glued or even screwed to almost any surface. It comes with a Stainless Steel spring clip so it can be removed when not in use. Like the others it will mount vertically or horizontally.
Each of these lights has two waterproof, threaded sockets that the mounting hardware will fit. One is located at the bottom of the barrel and one is on the side. If you are using a suction cup, for instance, it can either be screwed into the end or the side of the unit.
The following applies to all three lights:
# Requires 4 "AA" Batteries (Not Included)
# Molded One Piece White Body Construction
# Shock Resistant Neoprene Accents
# Rated at 100,000 Hours LED Service Life
# Uses 90% Less Energy than Incandescent
# Sealed Heavy Duty On/Off Switch
# Insert Molded Brass Threaded Mounting Bushings
# Removable Lamp Carriage Assembly
# Fully Buoyant
You may also need a Combination Bow Light